Menu
Ready-to-drop-in parts put an ultra-smooth, clean breaking, professional quality trigger job in your 1911 Auto in only minutes. Fully prepared hammer and pre-ground, pre-polished sear, plus springs and fully-machined disconnector, will install into most models of 1911 Autos with little or no fitting required.
thinking about trigger job... 5.5lb to a 3.5lb trigger pull. there is a lot of
Controversy over this subject. Some say if you get into a shooting they will target you as a Rambo and it will have some affect on the jury. Some say you will blow off your nads getting it out of the holster. Some say they had problems with these modifications. I would like to hear from others that did it/ didnt do it and why Pros and cons of why, these parts are cheap and easy to install. The whole thing is only 23.00 and 20 minutes to do it.
First off I want to thank every one for there input. Opinions hold a lot of weight legal and mechanical. the parts just came in and I went and put 2 of the 3 parts. Connector (first) and trigger spring (second) only. I still have the 4lb F/P spring and have not installed it yet. holding off for now and Wow what a difference. At first I was worried about an ND ( pulling out of the holster and accidentally making contact with the trigger and it going off with a liter trigger .There is too much resistance with the 6 lb trigger spring to get travel out to just touch and fire. There is just as much resistance getting the travel out as there in pulling the trigger now so what you get is almost a consist pull all the way with a slight difference in travel at the contact point to fire. Cant wait to get out to the range to try it out. 5 minutes and one pin to do the whole job